Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Stair Bulkhead needs raising

  • 27-10-2017 10:14am
    #1
    lilhedda
    Registered Users, Registered Users 2 Posts: 18 ✭


    We recently installed a new stairs as part of a renovation. The old one was ridiculously steep and narrow. The house is a typical 1950s build and everything in it was put in badly measured and misaligned. Since it went in the overhead stair bulkhead needs raising something our architect failed to spot. The current one slopes up from a box in the boxroom. Its basically ply wood that slopes upwards inside the box going up to join a stud wall. There is nothing load bearing near it. No electrics or plumbing near it either. Ideally we would make the box taller and a little deeper in depth and build a new mdf storage cupboard over it. The slope would start higher up and be steeper to help lessen head bumping. Has anyone else done similar? And what sort of cost is involved to do this type of work? Any information is much appreciated. Thank you in advance!


Comments

  • #2
    tabby aspreme
    Registered Users, Registered Users 2 Posts: 4,099 ✭✭✭tabby aspreme


    Are you sure none of the parts are load bearing , I think there would have to be a trimmer carrying the ceiling joists at the base of the slope that will have to be moved, it's not a big job to change it, but it's messy as you need a carpenter and a plasterer , bad miss by the architect as stairs headroom is part of building regs.


  • #3
    the_pen_turner
    Registered Users, Registered Users 2 Posts: 7,596 ✭✭✭the_pen_turner


    tabby aspreme wrote: »
    Are you sure none of the parts are load bearing , I think there would have to be a trimmer carrying the ceiling joists at the base of the slope that will have to be moved, it's not a big job to change it, but it's messy as you need a carpenter and a plasterer , bad miss by the architect as stairs headroom is part of building regs.

    exactly. what kind of architect could miss this.
    this is a simple enough job bit it is messy and will cause a bit of damge to ceilings etc.

    will have to take down some of the ceiling downstairs or up the floor so that you can fit a new trimmer. then rebuild a stud wall


Advertisement