Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Wanted for an International 674 Tractor

  • 10-02-2017 1:54pm
    #1
    mykidtractor
    Registered Users, Registered Users 2 Posts: 5 ✭


    New poster here looking for help please......

    Looking for any idea where I can source a pair of doors to suit a international 674 tractor please, (with or without glass, I don’t mind if there is some work is required on the doors).

    (Most of the breakers don’t seem to have them as these doors are scarce).

    I will pay the going rate for the doors depending on condition.

    I am based in midlands but I don’t mind collecting/travelling.

    I want to restore the tractor to do a small bit of work, topping, spraying etc etc.


    Thank you.


Comments

  • #2
    shot_ov_a
    Registered Users, Registered Users 2 Posts: 43 ✭shot_ov_a


    Did u try mcdonagh engineering? I have a pair there myself they are very rough tho need a nice bit of work..


  • #3
    Farmer
    Registered Users, Registered Users 2 Posts: 750 ✭✭✭Farmer


    Conaty's were selling a spurious replacement, at least for some of the newer models. It was basically a sheet of something around 1.5 to 2mm flat steel with just a 6mm x 25mm (maybe 30mm) flat steel as the door frame, rather than the complicated box frame of the originals.

    Was about 200

    Shouldn't be too hard to make up either esp. if you were doing two. Start with the glass and allow around 5-6mm all around for the rubber. Copy the rest from the originals.


  • #4
    mykidtractor
    Registered Users, Registered Users 2 Posts: 5 ✭mykidtractor


    Thank you will check mcdonagh and conatys.


  • #5
    Limestone Cowboy
    Registered Users, Registered Users 2 Posts: 3,555 ✭✭✭Limestone Cowboy


    I have one off a 784 here if it's the same.


  • #6
    Base price
    Registered Users, Registered Users 2 Posts: 11,459 ✭✭✭✭Base price


    You could try Tommy Shannon (pronounced Shane-an) near Killeshandra, Co. Cavan. The last time I was there they had some IH's in the yard.
    https://www.cylex.ie/company/shannon+tommy-11140276.html


  • Advertisement
Advertisement