Access control systems

Coddy76 · 2017-01-06 14:21:15

Could someone please tell me how I wire a three gang break glass into a access control system,I have no problem with the push button but I can't seem to break the Maglock power with the BG.help would be much appreciated.

06-01-2017 02:21PM

#1

Coddy76

Registered Users, Registered Users 2 Posts: 14 ✭

Join Date: January 2017

Posts: 8

Could someone please tell me how I wire a three gang break glass into a access control system,I have no problem with the push button but I can't seem to break the Maglock power with the BG.help would be much appreciated.

0

Comments

#2 08-01-2017 12:10PM

ZENER

Registered Users, Registered Users 2 Posts: 6,167 ✭✭✭

Join Date: April 2003

Posts: 5939

Normally the power to the Maglock is broken through a microswitch in the BGU.

Not sure if it's still the case but it used to be a requirement that power to any emergency doors was interrupted directly through a local physical switch rather than a controller device. Similar to emergency stop buttons on machinery or lifts.

Ken

0
#3 08-01-2017 12:30PM

Coddy76

Registered Users, Registered Users 2 Posts: 14 ✭

Join Date: January 2017

Posts: 8

OK, thanks very much for your help.

0