Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

AirTech CS350

  • 01-09-2016 10:41am
    #1
    briangu73
    Registered Users, Registered Users 2 Posts: 3 ✭


    Hi guys,

    I know this has been done to death but I just move into a new house and before i had a change to figure out the existing alarm we were burgled - what are the chances?

    Anyway the alarm is an AirTech CS350 - I have no codes from previous owner - the control panel in the hallway is blank and the alarm is turned off. The control board is located in the hot press.

    Is there anyway of resetting back to factory defaults without the alarm going off? I guess I will need some codes to reset it - any help appreciated.

    I am not too bad with a screw driver so I would feel ok about removing battery resetting panels etc.


Comments

  • #2
    degsie
    Registered Users, Registered Users 2 Posts: 8,755 ✭✭✭degsie


    There is a jumper you can remove (LK1) while the unit is powered down, on powerup the unit should factory reset. You need to power back down and replace the jumper. This will only work if the unit is not 'engineer locked'.


  • #3
    KoolKid
    Moderators, Home & Garden Moderators, Technology & Internet Moderators Posts: 24,789 Mod ✭✭✭✭KoolKid


    If it is engineer locked most good installers can reset it for you.


Advertisement