Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Splicing ribbon cable

  • 30-05-2016 7:22pm
    #1
    gaffer falls
    Registered Users, Registered Users 2 Posts: 36 ✭


    Plastic grey ribbon cable on an piece of equipment has been damaged by someone driving a screw through it damaging 4 of the wires .Is there a snap on male/female connector that I could use to splice it having cut out the damaged piece?Don't feel confident about delicate soldering on pcb boards.


Comments

  • #2
    DublinDilbert
    Registered Users, Registered Users 2 Posts: 5,401 ✭✭✭DublinDilbert


    gaffer falls wrote: »
    Plastic grey ribbon cable on an piece of equipment has been damaged by someone driving a screw through it damaging 4 of the wires .Is there a snap on male/female connector that I could use to splice it having cut out the damaged piece?Don't feel confident about delicate soldering on pcb boards.

    If it's only 4 wires damaged, just bridge the gaps in each conductor will 4 bits of wire soldered into place... You could also use some heat shrink on it....


Advertisement