PVC door adjustment

99nsr125

I have a terrible gap between the door and frame at the bottom of the lock and handle side, (as in the Z direction) from the door lock down , worst at the bottom. I call this the bottom right

It's evenly gapped everywhere else.
Latches alright
Locks alright
Rollers pull up alright

I'm too tired for my brain to work properly to even it up all around without making it leaky at the top left.

Please help

Wadpie

Adjusting the bottom hinge shouldn't effect the cover on the rest of the door. You'll need Allen keys to adjust the hinge

99nsr125

Yup

I have the allen keys, I can't figure out how the bottom right corner is lifting away from the frame when the other sides are flush.

septictank

Is it the horizontal(bottom left to right)(door lifting up) or the vertical (right hand side top to bottom) that is pulling away from the frame?

If the Horizontal then adjust the top hinge in the top center, door will come down.
If the Vertical adjust the bottom hinge at the side or bottom depending on make to make the door move over to the right.

Wadpie

99nsr125 wrote:

I have the allen keys, I can't figure out how the bottom right corner is lifting away from the frame when the other sides are flush.

Can you post a picture of the gap and the hinge? Method of adjustment will differ from hinge to hinge