Triton t90z no flow after tank emptied (and refilled)

kosie

I had a new sink installed in the kitchen and the water tank in the attic was emptied. When all work was done and the water supply opened up again, I allowed the attic tank to fill up again overnight.

But now this morning, no water is coming out of my t90z. I then opened the bleed screw and let than run for a few minutes and sure enough there was some spluttering before it ran with a steady flow.

I then turned the shower on again and water came for 10 seconds before it stopped again. I bled it again, but exactly the same thing happened

Is there anything else I can do to get this fixed?


Thanks!

kosie

Just got it sorted. It was air locked as I suspected, so I phoned Triton (very helpful) and the lady suggested the following, which worked:

1.) Turn both dials to cold
2.) Let show cord hang down in the bath
3.) Turn shower on for 30 seconds a few times during the day until air lock removed

I only had to do it once for 10 seconds.

Yay!

kosie

Just got it sorted. It was air locked as I suspected, so I phoned Triton (very helpful) and the lady suggested the following, which worked:

1.) Turn both dials to cold
2.) Let shower head/cord hang down in the bath
3.) Turn shower on for 30 seconds a few times during the day until air lock removed

I only had to do it once for 10 seconds.

Yay!