4230 Case- Very hard started

sean.walsh123

very hard to start in morning.hav to use jump leads.new battery in an a new high spin starter
tractor hasnt much work done .in at night . its a torture to start

raypallas

Does the engine just keep swinging until the battery goes flat? could it be poor compression or poor injector pump?

valtraman

Is the engine turning over quickly before jump leads ,if not you have a poor connection on one of the main leads probably a poor earth .After trying to start it check if any of the lead connections are hot (mind for burnt fingers ) Is the diesel tank below the engine level on that model ,if so diesel is getting back to the tank and air into the pipes ,assuming everything is good once started

stanflt

There are only 2 lads that I know that can successfully fix all the problems with that particular model of tractor- Patterson and maguire

selectamatic

Do these yokes have the engine stop plunger that you pull out to stop the engine like on the 885xl's? If so you are supposed to pull the plunger out half way when starting as it acts like a choke then quickly push it back in when the engine fires you might need a wee rev on to stop it stalling too.

If these are different to the 885xl's then the above probably won't be applicable to ya.

tomwaterford

Is the primer on the side of the filters working??

tismesoitis

Check heater plugs.

sean.walsh123

new heater plug opened diesel filter no diesel it seems to be lettin back diesel

Muckit

she'd be a very poor yoke to need the heater plug to start this weather in fairness!!

No word of a lie, l seen two flies climbing the wall last Saturday! Flies in December. .. ah come on Ted!

sean.walsh123

i haerd a cuckoo saterday morning

jimmy G M

Muckit wrote: »

she'd be a very poor yoke to need the heater plug to start this weather in fairness!!

No word of a lie, l seen two flies climbing the wall last Saturday! Flies in December. .. ah come on Ted!

Did you throw on a bet?

The Sidewards Man

sean.walsh123 wrote: »

i haerd a cuckoo saterday morning

Lay off the poteen and fit a non return or find the source of the problem with your tractor.

johndeere3350

It a non return valve on the line should solve your problem

sean.walsh123

4230 .put in new heater plug.fitted new diesel pipe to heater plug.replaced primer on side of filters .big improvement.the jurey is still out on it yet.

sean.walsh123

building shed to suit machinery but also want it high enough so that i can back in an artic of straw any sugestions