Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Kitchen wall problems

Comments

  • Banned (with Prison Access) Posts: 3,571 ✭✭✭newmug


    Looks like you might have damp problems. If I was you, I'd scrape off all the loose material, and slab the walls with 50mm insulated slabs. Skim over them, coat of paint, your walls will be as good as new.


  • Registered Users, Registered Users 2 Posts: 1,445 ✭✭✭sky6


    Before you effect any remedy you need to identify the cause of the problem. It could be as little as not enough ventilation in the room. Check that there's no damaged or overflown Gutters outside allowing water to run down the Wall causing the Dampness. I wouldn't slab to clean up and hide the problem. That will only make things worse and a danger to health.
    Solve the root cause first then you can slab or get it re plastered.


  • Registered Users, Registered Users 2 Posts: 152 ✭✭tmccar


    The plaster that is breaking up is actually on an inside wall. The issue I have with the other 3 walls are that the paint if flaking off. It looks like the paint went directly on the hardwall.
    Should it have been "sealed" first?


  • Registered Users, Registered Users 2 Posts: 1,445 ✭✭✭sky6


    If you are confident that the Wall is dry and that there are no problems then you could remove all the flakey bits. Scratch the Wall up through the paint to provide a key. Then give it a coal of Thistle Bond and get the wall skimmed coated again.
    This would be the cheapest and best solution. It'll look like a new room.


  • Registered Users, Registered Users 2 Posts: 152 ✭✭tmccar


    The kitchen was once a cloakroom of an old school. As you can see, the coat hangers are still there. I have pulled down some shelves and you can see the gouge that was made in the plaster after doing this. It doesn't seem to be good quality plaster.
    I would like to keep the coat hangers (or at last replace them after I get the wall sorted out).
    The wall is quite uneven also, having some bumps and hollows. I don't think any wood laths were used.
    Any further advice would be appreciated.

    [IMG][/img]20150910_2201551_zpsdqevyhki.jpg


  • Advertisement
Advertisement