Put your hacks here...

Papa_Bear · 2015-05-29 03:27:51

And as they say... Here's one I made earlier. It's a circular saw (or table saw when upside down and in my custom made bench top) using an angle grinder and the sole plate from an old circular saw on which the gearbox went. And here is a close-up of the method used to attach the grinder. It runs pretty good too.

29-05-2015 03:27AM

#1

Papa_Bear

Registered Users, Registered Users 2 Posts: 208 ✭✭

Join Date: September 2009

Posts: 173

And as they say...

Here's one I made earlier.

It's a circular saw (or table saw when upside down and in my custom made bench top) using an angle grinder and the sole plate from an old circular saw on which the gearbox went.

And here is a close-up of the method used to attach the grinder.

It runs pretty good too.

2