Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Nissan Almera 2.2 dc, several error codes

  • 15-04-2015 6:47pm
    #1
    mitzymayo
    Registered Users, Registered Users 2 Posts: 2 ✭


    Hey can anyone help.
    I have a 03 almera van. When I try to start it it runs for 2 or 3 seconds then knocks off. Sometimes it will start and run, when it does it runs perfectly.
    The engine management light is on and getting codes p0335 p1251 p1690 p1337. Can anyone help, my head is driving soft trying to figure it out


Comments

  • #2
    biko
    Registered Users, Registered Users 2 Posts: 81,220 ✭✭✭✭biko


    Are you reading the codes, or a mechanic?
    How long has car been like this?
    Any work done on it recently?


  • #3
    mitzymayo
    Registered Users, Registered Users 2 Posts: 2 ✭mitzymayo


    biko wrote: »
    Are you reading the codes, or a mechanic?
    How long has car been like this?
    Any work done on it recently?

    A mechanic showed me the codes to check I bought the van sat I was told it was a crank shaft sensor but I replaced it and its still the same the rev counter doesnt work when you start it it reves up and goes back to idle if it stays running


  • #4
    biko
    Registered Users, Registered Users 2 Posts: 81,220 ✭✭✭✭biko


    I suggest to bring it to another mechanic and let them have a look too.

    I am moving this to main forum as it's not a DIY effort.


Advertisement