Airsoft Guns, G36, PT99 plus magazines and furniture

Stonewolf

I'm leaving the country so I need to sell off my guns.

I AM NOT ACCEPTING TRADES

Collection: Yes (South Dublin)
Courier: Not for the guns, otherwise yes

Cash: Yes
Paypal: No (their fees are outrageous)

All chrono values are in FPS with 0.2g BBs and were taken indoors with a Madbull chrono


Type: G36
Manufacturer: Ares
Chrono: 265
Details: This started out as a stock Ares G36k but has the foregrip swapped for the full battle rifle foregrip with integrated bipod and the carry handle replaced with the rail from the c variant. The outer barrel consists of a k variant barrel screwed into the receiver with a battle rifle barrel screwed onto that tipped with a tuning fork style flash hider. The inner barrel is a Prometheus 6.03 tightbore and extends the full length of the outer barrel and is iirc 590mm. The gearbox has has some basic mods for robustness and to account for the extra long barrel. The hop-up is a stock Marui clone with a Guarder clear rubber. The cylinder is on this gun is intact and it has been downgraded by use of a lower power spring. This gun has a low chrono reading because of an air leak suspected to be poor matching between the barrel/rubber/nozzle, I'd recommend the buyer experiment with different rubbers and air nozzles. I've used this as more of a long range gun firing on semi with heavier BBs, with some care to the air seal and addition of an appropriate optic with good eye relief this would make a great DMR.
Asking: 160 due to poor air seal
Pictured items included, hi-cap, cleaning rod. Battery subsequently turned out not to hold a charge


Type: G36 furniture
Manufacturer: Various
Details: This is various furniture I've accumulated for the G36 above, It consists of receiver with 3 body pins (Star), carry handle with integrated zoom optic and small rail (Ares), k type foregrip (Ares), magwell (Star), basket and tuning fork style flash hiders (unknown), bayonet lug (Star), small rails with screws which fits the vent holes on the k foregrip (unknown)
Asking: 40

https://lh4.googleusercontent.com/-RsoyZTwZ-v8/VOuiMepSwtI/AAAAAAAABOU/Yi5gMCs6yvA/w1185-h889-no/20150223_210040.jpg
Type: PT99
Manufacturer: KWC
Chrono: 245
Details: This is the used gun pictured top right, it comes with two magazines (one long, one short). It's full metal and fires fully automatic or single shot. It takes CO2 only and is GBB. These things are absolutely great (as you can see from my having had two), they're loud, fun, have a lovely kick and won't let you down in cold weather. If you haven't had the opportunity to play with one of these don't let this one pass! I'm selling the more well worn of my two as the other has already been sold, I've had it for 5 or so years and it was bought used from Hobby Airsoft. It shoots well and doesn't give any trouble if occasionally stripped, cleaned and oiled.
Asking: 65


Type: G36 Magazines
Manufacturer: DBoys
Capacity: ~50
Details: Nice fake bullet midcaps that hold about 50 BBs and have a small probe on the pusher that reduces BBs in the tube. These have given me good service and I haven't known them to jam.
Asking: 5 each

Type: PT99 Extended Magazines
Manufacturer: KWC
Capacity: ~39
Operating Gas: CO2
Details: Extended CO2 magazines for the PT99, will not fit other berettas. These use 1/4 inch allan keys, I can provide some cheapo ones if needed. Usual caveats apply RE gas magazines. Selling 5 of the pictured magazines.
Asking: 15 each

Stonewolf

bump

Stonewolf

bump

Stonewolf

Dropping the price on the guns to 170 and 70.

Stonewolf

Dropping the prices:
160 for the G36
65 for the PT99
40 for the furniture
5 each for the magazines
15 each for the PT99 magazines

Gatling

Offer €30 for the G36 furniture i can collect

Stonewolf

Accepted, PM for details

Stonewolf

I'll be leaving the country soon, anything that's not sold will be going in the recycling.

sharpy2010

When you say the pt99 mags won't fit other berettas does this include the pt92 also

d.one

I'll take 3 long mags if they are leak free for 30€ collected pal?

Stonewolf

They should be leak free yeah, they were all checked out by Hobby a while ago and haven't given trouble since. Accepted at 30.

Sharpy, I don't know about your pt92, it would depend on manufacturer probably. I know they don't fit the common KJW M9 so if thats mags fit I would say no. Otherwise I'd suggest you have a google for it.

Stonewolf

Bump

Stonewolf

Dropping prices to:
G36: 150 (daylight robbery)
PT99: 60
Remaining 2 PT99 mags: 10ea

cold sweat

Will take four g36 mid caps.

Stonewolf

cold sweat wrote: »

Will take four g36 mid caps.

Accepted at asking

Jalaldin

pt99 pistol with two magazines still available?

Ger7000

Is the g36k still available