HK416 bits and peices

smurfDe · 15-03-2015 5:28pm #1

Gear box Ver.2 ,Rear wired with mosfet+ deans connection, new M90 spring never used, with new spring guide full metal, has a great rate of fire, taken from a HK416 Classic army , taken care of , shimmed and greased.

1.Pistol grip with plate and screws

2.High Torque factory motor

3.Stock tube and screw

4.Lower receiver off a HK416 Classic army, has a chip taken off the pin holes as seen in the second photo ,has been that way since I had it and never effected the gun itself. Plastic sports line.

5. Hop Up and barrel (factory)

6.Upper Barrel and Upper Receiver this comes with the original iron sight and foldable sight, all original parts including flash hider, Upper receiver and the RIS rails are all durable ABS plastic all other parts are metal. Little cosmetic damage bar one, the bolt realise is missing, which has no effects on the performance.

7.Full plastic stock , no damage bar cosmetic

8.Display Li-Po Battery Status Indicator

This gun was always reliable , its 3 years old , had seen its fare share of skirmishes , selling to fund another project.

Will be selling everything for €65 , buyer will be paying for postages.

Will break and sell individually if there is enough interest.

when assembled last was firing around the 280 fps mark