Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

insulate timber shed

  • 12-02-2015 8:26pm
    #1
    brock92
    Registered Users, Registered Users 2 Posts: 206 ✭✭


    Hi, I just got a new timber shed 16x10 and would like to insulate it. The battens are only 2 inches. What would be best way to insulate? Use 25mm kingspan slab with small air pocket front and back. Then sheet over with ply. Plus have vapour barrier between slab and ply. Would this work OK or be a waste of time?


Comments

  • #2
    M.T.D
    Registered Users, Registered Users 2 Posts: 396 ✭✭M.T.D


    Hi
    No gap between insulation and ply then water/vapour barrier then shed. you can get aeroboard (polystyrene) in 2"/50mm thick sheets not as good as 50mm kingspan but should be quite adequate and a lot cheaper.
    If you are screwing the ply to the battens it should make the shed rigid as well.


Advertisement