Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Dev ComFlt for ID Contact/Inertia Sensors

  • 08-02-2015 1:59pm
    #1
    Registered Users, Registered Users 2 Posts: 24


    Hi,

    I have a HKC SW1070 that I installed myself 2 years ago.
    Lately I am getting the following errors "Dev ComFlt" for all the six ID Contact/Inertia Sensors connect in parallel to the same Zone.

    Can anyone give me guidance to debug this fault.

    Thanks
    Cathal


Comments

  • Registered Users, Registered Users 2 Posts: 11,917 ✭✭✭✭altor


    ckinane wrote: »
    Hi,

    I have a HKC SW1070 that I installed myself 2 years ago.
    Lately I am getting the following errors "Dev ComFlt" for all the six ID Contact/Inertia Sensors connect in parallel to the same Zone.

    Can anyone give me guidance to debug this fault.

    Thanks
    Cathal

    Replied here

    http://www.boards.ie/vbulletin/showpost.php?p=94218604&postcount=11


  • Registered Users, Registered Users 2 Posts: 24 ckinane


    Thanks Altor,

    The next time it happens, I will open each device and check the Led status.


  • Registered Users, Registered Users 2 Posts: 11,917 ✭✭✭✭altor


    ckinane wrote: »
    Thanks Altor,

    The next time it happens, I will open each device and check the Led status.

    If it is an intermittent problem you may have an issue with a cable.


  • Registered Users, Registered Users 2 Posts: 7 BoardLK


    Hi
    I had a similar problem with a commFlt. The issue appeared to be a noisy (RF noise) (when switching) thermostat sending noise into the cable. Replaced the thermostat with a higher quality one and have not seen the problem since, touch wood.


Advertisement