Airsoft Dmr build

nfsman

i was just wondering what would be needed to build a airsoft Dmr loadout with the irish limit. im considering doing it to a cm16 raider as i bought a new gun that i will use for assault roles.

sharpy2010

I wont say slap on scope and a bipod but essentially that all with look like as its the internals to be done.
what you could do is start with a tightbore barrel, good hop up rubber, check your air seal in the gearbox and then you can look at motors, gears etc.
But if your on about externally then the world is your oyster but just remember DMR is still used by marksmen and not support people so avoid the boxmags at all costs, unless you want to have 1 fine but traditionally your no longer practicising markmanship principles just laying down support/suppresive fire.

nfsman

No i Snipe quite alot and i had a modifeid jg bar 10 giving to me by my brothers friend who was leaving the sport. but i want to try out Marksman roles you know i have a strike force scope and a suppressor. i have in the gun a tighbore already and a metal flat hop unit. but i want to try and get the best range possible

driftrs13

If you want range get a Tanio Koba barrel, they are expensive but give great range. A MOSFET and Lipo battery will give you a better trigger response.

Foxhole Norman

I'd use a Gen3 G&G M16A4 that comes standard with a Hi-Torque Motor, 6.03MM Tightbore and a Mosfet. Very accurate out of the box. Add a scope and you're laughing.

YbFocus

On my g3 dmr I run a 6.03 psg1 590mm barrel, coupled with a type 0 cylinder so I get maximum airflow.
I found guarder clear hop up rubbers to suit my gun really well so that's what I run.
Its amazingly accurate and runs right at the top end of the distance when it comes to Irish airsoft.

It's all aesthetic after that.

I love showing it off so I'll stick up a pic a bit later

nfsman

Do stick up some pic's i love seeing other people machine's . Do you know where i could get a type 0 cylinde?

YbFocus

You can get a type 0 anywhere, but it must conform to your barrel lenght, only use a type 0 with a 450mm+ barrel Otherwise it runs the wrong airflow for your barrel and will make things ar worse!

As for pics, here you go

matty1994

I have my m14 dmr, standard motor, g&g gears, polycarb piston and piston head, type o cylinder, standard barrel, massive scope and massive silencer, great rof if needed but has an amazing trigger response, also bang on 320fps +/- 3 fps, will get a picture up