How to separate heat controls from water controls?

jx

I have a fairly new condenser boiler (Murelle EV HE 35) that can control 2 channels, water and heat, but currently heating and water are working as 1 channel. So, you only get hot water if you have the heating on.
I'd like to change that, and install whatever is necessary. How do I do this?

jx

Also, the manual (http://portale.sime.it/jportal/pcontroller/ExtensionHandler/6274270%20-Murelle%20HE%2025-30_55%20GB%20-Inst.pdf) says the boiler can use remote (radio) valves and sensors.

rightjob!

jx wrote: »

I have a fairly new condenser boiler (Murelle EV HE 35) that can control 2 channels, water and heat, but currently heating and water are working as 1 channel. So, you only get hot water if you have the heating on.
I'd like to change that, and install whatever is necessary. How do I do this?

if you cant separate them in the hotpress you will have to install two pipes from the boiler to your cylinder and then you a motorized valve