Lift arm problem

Irishmale

The arms on the JD 6320 wont lift enough for the hitch to unlock. especially with a trailer on. A bit of fiddling between the draft and the outside buttons and that it jumps up another bit. Also, this has started beeping 5 times when i turn it on. Any ideas?

aidanki

any error codes

Rho b

Did you check the hydraulic oil levels?

Justjens

You can also tighten the lift rods, remove at the bottom and tighten one or two turns, just keep them even.

Can't help on the beeping tho............

aidanki

Is the battery good in it ?

saw this when the battery was on the way out on a 20series, it would beep at start up and flash a warning about low system voltage

in the end it would conk out when lights were turned on

porterhole

Beepin may mean service interval time is up

Irishmale

gave the lift rods a turn and its working better thanks. Hydr levels are sound. No err codes but it must be a sensor. it goes beep-beep-beeeeeeeeeeeeeep-beep-beep. Had an agrotron and when it flashed like that it meant sensor 3-2