NordMende DFSN60 dishwasher error codes

nosedive

Hi all, need a bit of help with error codes on the machine in the title. I had an F6 error so replaced the heating sensor and element after which the machine ran fine for a day or two - then the same code repeated itself and the machine stops after a minute at so same as it did the first time.

Is there anything I need to do to reset the error codes for the dishwasher to run normally again or is the repair a bad one?

Obviously I'm trying to save a few quid here having had a repair done already - any and all advice is welcome and appreciated.

e46318ise

nosedive wrote: »

Hi all, need a bit of help with error codes on the machine in the title. I had an F6 error so replaced the heating sensor and element after which the machine ran fine for a day or two - then the same code repeated itself and the machine stops after a minute at so same as it did the first time.

Is there anything I need to do to reset the error codes for the dishwasher to run normally again or is the repair a bad one?

Obviously I'm trying to save a few quid here having had a repair done already - any and all advice is welcome and appreciated.

Thread resurrection.

I just got the same error..
Anyone got experience with these? I previously had it repaired under warranty as the wiring had melted itself, it is now well out of warranty.

The Red Ace

ideally you need to be able to use a meter to check the element for open circuit, (blown) if you can do this and the element is ok it is either not getting a supply from the board or the loom coming down is broken, often at the bottom of the door edge

jaytobe

Anyone know how to repair the F9 error code 'Divider Error) for this appliance?