BB set question

Kek

Hi, I have a felt dispatch 2010. The Bottom bracket is starting to creak because it has never been cleaned, every shop I've been taken the bicycle to just offer to replace it with out even checking it. So I have decided to work on it my self, but when trying to read online about bottom brackets I cant find any good information, apparently there is a million of different ones and I'm not able to buy the proper tools, since there are 4 options of BB set removers, etc.
Could any one point me in the right direction, so far these are the options I have to buy. I'm just not sure they will fit...
I also cant find these tools in big bicycle shops like eurocycles and a couple more around town. Even tho their websites say they sell them

BB tool
http://www.ebay.ie/itm/Icetoolz-BB-Bottom-Braket-Tools-/130657846288?pt=UK_SportsLeisure_Cycling_BikeLocks_SR&hash=item1e6bd08410

bb tool#2
http://www.ebay.ie/itm/NEW-Icetoolz-Shimano-ISIS-Drive-BB-Tool-/130657893134?pt=UK_SportsLeisure_Cycling_BikeLocks_SR&hash=item1e6bd13b0e

crank tool (too expensive!)
http://www.ebay.ie/itm/2013-New-Icetoolz-Crank-Tool-Ergonomic-Handle-/130773290520?pt=UK_SportsLeisure_Cycling_BikeLocks_SR&hash=item1e72b20e18

TheBlaaMan

Your bike has what is referred to as a "square taper" bottom bracket, (according to here) and I'm not surprised a shop wont offer to service/clean one - they are effectively a replaceable, consumable part. By your own admission, it has been neglected, so any work on it is most likely futile and no shop would want to be asked to stand over any remediation of a shot BB.
I dont know what BB is suitable, most likely something like this but in any case the part is going to be less than €20 and you'll pay maybe another €30 for fitting. Compare that to the tool that will cost €15-20 and you might be best to put it down to a lesson learned......

Crankset FSA Vero, 39 teeth
Bottom Bracket FSA square taper
BB Shell Width 68mm

Kek

thanks for your answers, it cleared a lot of doubts.
found a nice crank tool in eurocycles. Im still a bit confused over which tool would work to remove the BB, would you say an ISIS compatible one can do the job?

Chips Lovell

No, Isis is a different standard to square taper. The first tool you linked to will handle a square taper. You'll also need a crank puller to get your cranks off to get at the bottom bracket. And a big adjustable wrench. And a new bottom bracket.

Kek

Vladimir Kurtains wrote: »

No, Isis is a different standard to square taper. The first tool you linked to will handle a square taper. You'll also need a crank puller to get your cranks off to get at the bottom bracket. And a big adjustable wrench. And a new bottom bracket.

thanks vladimir, thats whats confuse me, they say shimano/isis compatible, would this one work?
http://eurocycles.com/ie/product/xlc/inner-bearing-tool-to-s05
I the crank puller is standart for all brands? I ordered this one:
http://eurocycles.com/ie/product/xlc/crank-puller

Chips Lovell

Actually, the isis splined ones do seem to take off bottom brackets using the Shimano standard.

I've only ever worked on Campagnolo and Miche square taper BBs, so I thought they all used the same standard.

You need to figure out which one your FSA BB is.