Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)

Shooting Forum - Firearms licencing information


Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Ruger 10/22 Scope Rail problem

  • 10-04-2013 12:06pm
    #1
    Comeraghshooter
    Registered Users, Registered Users 2 Posts: 192 ✭✭


    Some advise please,

    The scope rail on my Ruger is slightly loose -the two back screws on the rail keep turning and don't tighten, screws look ok so i think its the threads on the receiver are the problem.

    What are my options?


Comments

  • #2
    IrishTarget
    Registered Users, Registered Users 2 Posts: 138 ✭✭IrishTarget


    Lock tight them screws with medium strength lock tight.

    Is it a new ruger?


  • #3
    Comeraghshooter
    Registered Users, Registered Users 2 Posts: 192 ✭✭Comeraghshooter


    Its about two years old, ill give that a try thanks.


  • #4
    clivej
    Registered Users, Registered Users 2 Posts: 7,072 ✭✭✭clivej


    NO do a proper job on it. Lock-tight is not the answer on stripped threads

    Re-tap them out to 4mm and then use 4mm screws.
    A 4mm tap will go right into the holes without the need to drill it out any more. Get the screws from Woodies.

    If the screw are to long then run a nut up on the thread and cut them to the size required and then take off the nut to make the end of the thread nice.


  • #5
    duckman!!
    Registered Users, Registered Users 2 Posts: 477 ✭✭duckman!!


    IrishTarget wrote: »
    Lock tight them screws with medium strength lock tight.

    Is it a new ruger?

    dont use lock tight, 1 knock and ur back to square 1!!

    clivej is dead right!!


Advertisement