Exhaust pipe bending

sbkenn · 14-08-2012 4:50pm #1

I am looking for someone to bend a very simple exhaust pipe. 3,90degree bends in with one end ending to fit over a 33mm pipe. radiai, 50mm or less. Pipe bent, or welded elbows are acceptable. Pipe for a stationary (Kubota) engine.
If anyone can advise, I would appreciate it

Mycroft H · 14-08-2012 4:59pm

sbkenn wrote: »

I am looking for someone to bend a very simple exhaust pipe. 3,90degree bends in with one end ending to fit over a 33mm pipe. radiai, 50mm or less. Pipe bent, or welded elbows are acceptable. Pipe for a stationary (Kubota) engine.
If anyone can advise, I would appreciate it

No local metal fabricators to help?

Mech1 · 14-08-2012 5:01pm

Location?

sbkenn · 14-08-2012 5:23pm

Balbriggan

Mech1 · 14-08-2012 6:00pm

Maybe too far, but I know a guy in dunleary that makes stainless exhausts he has all the hydrolic bending gear etc.

sbkenn · 15-08-2012 2:45pm

Dunlaoghaire wouldn't be a problem. I want to visit the maritime museum anyway.

Drummerboy08 · 15-08-2012 3:13pm

Souhans in trim co meath would probably do this too.

Mech1 · 15-08-2012 3:22pm

http://www.facebook.com/pages/Dun-Laoghaire-Motor-Worx/170216406363084

ok its this guy give him a bell.

I dont work there btw.

Sids Not · 15-08-2012 3:57pm

Mech1 wrote: »

Maybe too far, but I know a guy in dunleary that makes stainless exhausts he has all the hydrolic bending gear etc.

Alan (jumbo)....great guy...check out his amazin cossi while youre there...;)

He's right next door to J+S motor factors...

DoylerC · 15-08-2012 8:28pm

Custom metal works in Newtownmountkennedy should be able to sort you out, www.custommetalworks.ie, https://www.facebook.com/#!/pages/Custom-Metal-Works/160545310629528

Exhaust pipe bending

Comments