Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

HKC panel 10/70 v2.3

  • 09-06-2012 10:31pm
    #1
    Thunderbird2
    Closed Accounts Posts: 1,250 ✭✭✭


    Upgraded to a newer secure wave 10/70 panel . Noticed that the ID beams and older Mach 1 or 2 bell box seem to have a flickering haze when lighting up . As the lights on the bell flash side to side when the led lights up its bright then dims it then changes over to the next led which does the same . When the led on the ID beam lights up it also does a little dim .. Its the same effect as when the lights in a house flicker/dim . It seems like a PSU problem ?


Comments

  • #2
    fred funk }{
    Registered Users, Registered Users 2 Posts: 6,827 ✭✭✭fred funk }{


    Never seen that on a 10-70. Put your multimeter on the aux 12v and see if the voltage is dropping. I would also disconnect each powered device one by one and check each time if the problem goes. Could be a faulty device, most likely the old bell.


  • #3
    Thunderbird2
    Closed Accounts Posts: 1,250 ✭✭✭Thunderbird2


    Got it sorted . Thanks for the reply
    The problem was due to the fact that i didnt have the back up batt connected . Seems as though the psu was seaching for the batt


Advertisement