MODULATOR HELP

firemansam1

Basically I have the modulator shown in the pics attached.

Can anyone tell me how to set what channel it broadcasts the signal on.

I don't have the instructions, so even if someone knows what make/model it is that i could google it.

Thanks.

2012-04-10 14.58.35.jpg

2012-04-10 14.58.56.jpg

All help appreciated

There are 8no dip switches and each has only either on or off

aerial man

firemansam1 wrote: »

Basically I have the modulator shown in the pics attached.

Can anyone tell me how to set what channel it broadcasts the signal on.

I don't have the instructions, so even if someone knows what make/model it is that i could google it.

Thanks.

2012-04-10 14.58.35.jpg

2012-04-10 14.58.56.jpg

All help appreciated

There are 8no dip switches and each has only either on or off

up = 0
down = 1

it is similar to the one we used to use for CCTV "EDIT = the set up on Booms is completely the opposite than the modulator that i used! sorry for the confusion Below is the edited list

1=32
2=16
3=8
4=4
5=2
6=1
7= pal I when up, pal g when down ( leave up)
8= test,(gives a test bar so you can easily tune to the channel you are setting)

then you add 21 to the numbers you have set


for example for channel 69 (21+32+16) have peg 1 and 2 down

Here is a link that Booms has kindly posted with a full list of channels http://www.satcure.com/tech/rfmod_switches.htm

you can set any channel number with different combinations of switchs down from 21-69 (UHF)

hope its some help, i know it sounds very confusing!

Booms

Check out this page here:
satcure modulator instructions

looks like a similar device.:)

Oops! Didn't see Aerial Man's reply until I'd posted.

firemansam1

Just tried that aerial man, didn't seem to work.

I'm going to try again now.

Thanks

firemansam1

Booms wrote: »

Check out this page here:
satcure modulator instructions

looks like a similar device.:)

Oops! Didn't see Aerial Man's reply until I'd posted.

Will try this too.

Back in a few minutes!!!!

aerial man

What channel are you hoping to set?

firemansam1

Booms wrote: »

Check out this page here:
satcure modulator instructions

looks like a similar device.:)

Oops! Didn't see Aerial Man's reply until I'd posted.

Worked at treat!!!!

Thanks guys!!!!

firemansam1

aerial man wrote: »

What channel are you hoping to set?

Just trying to figure the yoke out for someone else.

Thanks

leex

Maplin sell the same one and I think the manual with dip switch settings may be on the product page.