Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Engraved switches/switch plates?

  • 03-03-2012 8:18pm
    #1
    Raiser
    Registered Users, Registered Users 2 Posts: 4,929 ✭✭✭


    Quick question, I'm rewiring two bathroom extractors so they are switched independently from beside light switch outside door (due to irritation over noise at night and also fan making room freezing during shower etc!)

    I'd like to get a little fan symbol engraved on one switch button in both cases (one 2 gang and one 3 gang) to avoid the obvious confusion.

    Can I do this myself - ie etch or engrave somehow? Buy specialist pen or something (!?) I'd like it to look clean and professional. Other than that I'd be happy to either send switches to a co. recommended on here or else just buy product outright etc.

    Anyway, any advice appreciated!

    Thanks


Comments

  • #2
    LeBash
    Registered Users, Registered Users 2 Posts: 3,583 ✭✭✭LeBash


    Raiser wrote: »
    Quick question, I'm rewiring two bathroom extractors so they are switched independently from beside light switch outside door (due to irritation over noise at night and also fan making room freezing during shower etc!)

    I'd like to get a little fan symbol engraved on one switch button in both cases (one 2 gang and one 3 gang) to avoid the obvious confusion.

    Can I do this myself - ie etch or engrave somehow? Buy specialist pen or something (!?) I'd like it to look clean and professional. Other than that I'd be happy to either send switches to a co. recommended on here or else just buy product outright etc.

    Anyway, any advice appreciated!

    Thanks

    I got this done in Pointer Controls in glasne in a few times. Nice finish and was not overly expensive


Advertisement