Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Immersion setting

  • 27-02-2012 10:32pm
    #1
    creedp
    Registered Users, Registered Users 2 Posts: 5,960 ✭✭✭


    This is probably a brutally obvious Q but I took off the cap of the cylinder immersion to check setting and found it has 5 setting numbered 1 - 5. Do these settings equate to temperature in celsius, i.e. 1 = 20deg while 5 = 100deg? Is so presumably therefore a setting of 3 or 3.5 should be OK?


Comments

  • #2
    freddyuk
    Registered Users, Registered Users 2 Posts: 1,113 ✭✭✭freddyuk


    I doubt it will go up to 100c. More likely 30 -60 c. I would set it at the lowest setting and see how hot the water gets and then go from there?
    Preferably get a new thermostat with temperature settings or check manufacturers website.


  • #3
    creedp
    Registered Users, Registered Users 2 Posts: 5,960 ✭✭✭creedp


    freddyuk wrote: »
    I doubt it will go up to 100c. More likely 30 -60 c. I would set it at the lowest setting and see how hot the water gets and then go from there?
    Preferably get a new thermostat with temperature settings or check manufacturers website.


    Thanks ... good suggestion .. that the problems with Board's, one can become very lazy!! Its also a problem with professionals who dump all the operating instructions.


Advertisement