Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Case MX110

  • 30-06-2011 9:34pm
    #1
    Xennon
    Registered Users, Registered Users 2 Posts: 931 ✭✭✭


    Howdy, have a problem where the PTO lever doesnt start the PTO, the switch on the lever doesnt seem to do anything, can the solenoid be wired directly to a switch? Or does it need to be connected to the tractors computer. Im basically wondering how the PTO is clutched, as I cant understand how it gets up to speed. Does the computer control a PTO clutch or something?


Comments

  • #2
    bigted2
    Registered Users, Registered Users 2 Posts: 43 ✭bigted2


    hi there it can one of three things that can cause your troubles
    1 fueses
    2 speed sender swich
    3 on /off leaver
    i had similer troubles mx100c


  • #3
    bigted2
    Registered Users, Registered Users 2 Posts: 43 ✭bigted2


    hi did you get your tractor sorted


  • #4
    Xennon
    Registered Users, Registered Users 2 Posts: 931 ✭✭✭Xennon


    yip, the controller computer unit was sent off and repaired, cost about €300 to do. The computer controls the PTO clutch so wiring the PTO solenoid directly is not a good way to go. We also had to replace the switch on the lever which was also buggered. That was about €45, but i found them on ebay afterwards of course.


  • #5
    Mx110
    Registered Users, Registered Users 2 Posts: 19 ✭Mx110


    Hi I am having problems with the pto in my case mx110 it seems to be in 1000 speed all the time no matter which way the lever is put. Pto was not used on the tractor for a few years could this mean a solenoid is stuck or something thanks


Advertisement