Semi sticking

damagegt

I just installed a extreme fire cheetah N2 mosfet in a KWA m16 Br and when I use semi the trigger gets stuck and doesn't return to the neutral position.I can click it back and fire again but again it will get stuck.Everything else works fine.Any ideas what this could be ?

ronan keane

Did you check the trigger spring?

Leftyflip

Trigger spring may be broken or not seated right giving you that result - it's a simple solution. Or it may be catching on wiring.

damagegt

I had a look yesterday and all seems fine.The trigger spring isnt broken or weak and there doesnt seem to be any wires in the way.Thats why im stumped.I thought it might have something to do with the mosfet.

MonkeyGuy

It's a bit strange that it doesn't stick on semi but does on full... Did you check the trigger contacts?

Leftyflip

Cut off lever may be catching on the trigger block or sector gear.

THE MINDER

damagegt wrote: »

I had a look yesterday and all seems fine.The trigger spring isnt broken or weak and there doesnt seem to be any wires in the way.Thats why im stumped.I thought it might have something to do with the mosfet.

Wont be anything due to the mosfet itself.You have a mechanical problem in the trigger mechanism.

damagegt

MonkeyGuy wrote: »

It's a bit strange that it doesn't stick on semi but does on full... Did you check the trigger contacts?

Its sticking on semi and not on full.I cant figure it out.Im going to have a good look over it tomorrow

damagegt

Had a look yesterday and the small arm of the trigger spriger was not seated properly.So an easy fix in the end.Cheers guys