Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

m4 mid caps not feeding

  • 27-06-2011 9:35pm
    #1
    thebrendanr1
    Registered Users, Registered Users 2 Posts: 192 ✭✭


    i have 6 m4 midcaps and none of them are feeding properly
    when they are out of the gun they still dont feed the bbs seem to be trapped down in the hole but when i shake the mag they rise up and this repeats until about 10 are left can any1 give some help i really need it :mad::mad::mad:


Comments

  • #2
    ronan keane
    Registered Users, Registered Users 2 Posts: 1,418 ✭✭✭ronan keane


    thebrendanr1 wrote: »
    i have 6 m4 midcaps and none of them are feeding properly
    when they are out of the gun they still dont feed the bbs seem to be trapped down in the hole but when i shake the mag they rise up and this repeats until about 10 are left can any1 give some help i really need it :mad::mad::mad:

    I had the same problem silicon oil fixes it


  • #3
    Arkslippy
    Registered Users, Registered Users 2 Posts: 1,061 ✭✭✭Arkslippy


    It could be a bit of debris.

    A little silicon spray will fix it, w5 from aldi is good as it has a straw type dispenser, simply push that down into the hole and squeeze for 3 to 4 seconds and shake. If the mag is loose a couple of wraps of electrical tape can help.


  • #4
    T4RGET
    Registered Users, Registered Users 2 Posts: 3,901 ✭✭✭T4RGET


    get a screwdriver and turn the little latch on the bottom of the mag, make sure you put your finger on it while you're doing it as it will fly away, now you can take the spring out and clean it and pass some water through the mag it self to remove everything, then silicon the spring an pop it back in.


Advertisement