Urgent - Setting up GT-10 with Amp !

drg85

Hey folks, sorry for the urgency! Basically I'm playing a an 80s themed musical at short notice for the next few days and I want to use my GT-10 with a laney GH100 amp / cab.

My ideal situation would be to set up the GT-10 with the laney with the following 2 presets (and maybe some variations of) available at my feet -->

1. A distorted tone (from the laney preamp) with maybe a touch of chorus etc from GT-10

2. A clean tone, modeled entirely from GT-10, essentially bypassing the laney preamp and using one in the GT-10 along with any effects such as chorus, delay, etc..

I've used the four lead set up before to use the GT-10 with laney but now I was to set it up so stomping 1 gives me laney tone with gt-10 effects and stomping 2 gives me the gt-10 modeled cleans with whatever effects through my laney cab, skipping over the laney preamp. Tonight in rehearsal I was using the gt-10 to control the drive channel on the laney and just switching it off for the clean sections but I'd MUCH prefer to use the GT-10 clean preamp.

Is this possible ? The sound engineer says it should be, and I think it involves have the S/R on , GT10 preamp off for 1 and the S/R off, GT10 preamp on for 2 but I have no idea how to do it.

Could anyone please help? I am a total tech idiot, so step by step with where I connect what lead and what I need to press on gt-10 would be amazing. Thanks so much!!

demanufactured

Dont think you can "bypass" and themps preamp in anyway when using the 4 cable method
Best bet at short notice woulds be to plug straight into the amp and use the gt10 for all your sounds.

feylya

You need to read the GT-10 manual. You have to organise the effects send location on the GT so your signal goes straight from the GT input to the effects in on the amp. Takes a while to get set up