Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

CV Boot Replacement on VW Caddy

  • 05-04-2011 7:22pm
    #1
    nophd08
    Registered Users, Registered Users 2 Posts: 473 ✭✭


    Hi All, How little do I need to dismantle to replace outer cv boot on passenger side of a 06 caddy tdi.
    If I undo driveshaft bolt, bottom balljoint, track rod, will I get enough clearance to swing hub out of way, also is there a circlip keeping cv together.
    Or is it easier if I remove driveshaft completely.
    Any help appreciated.


Comments

  • #2
    Slidey
    Closed Accounts Posts: 12,811 ✭✭✭✭Slidey


    You should get enough clearance at that.

    If not it is not that big a deal to just disconnect the hub from the strut to make enough room.

    AFAIK they are the same set up as VW have always used. Once you get the boot out of the way, grab the CV joint and pull it towards you. With a bit of tension on it, hit the outer edge of the joint with a hammer in the same direction you are pulling. It should just pop off with a few shots.

    It is only held in place by a snap clip on the shaft.

    There should also be a plastic domed washer and a spring washer on the shaft. Make sure you put these back as you found them and don't forget to fit the new boot AND clips before you put on the joint!


Advertisement