Trigger Gaurd Problem/Help?

Harveey

Hey Boardsies:D

Right well I ordered a trigger gaurd to swap out from the original one on my G&G M4, mainly because I noticed on a mate's gun how comfortable it was, I normally wear thick gloves, but anyways on to the problem.

I can get the front pin out well its pretty easy enough its just a push pin with a spring behind so it catches in the hole, that one is out. Now the pin at the back, just behind the trigger. Bastardly thing will not come out no matter what. I looked up about it online and a few people (not on this forum) where saying to ''drill it out or get a hammer to it''. Obviously I would consider that a last gasp effort but if anyone has any tip's or trick's that helped them changing the trigger gaurd I would really appreciate it

Cheers,

Harvey

3102derek

I used a hammer and dot punch to remove my one. it comes out easy enough

Harveey

Yes I eventually took the hammer out and lightly tapped a slightly larger nail into the pin and it eased out damn things are tricky though