Glass bedding a CZ452

6.5x55

Hi guys
I have just bought a new stock for a CZ452 .17 Varmint from Boyds in the USA and I want to Glass Bed it .I think that I saw a thread here about it can anybody point me in right direction or alternatively has any nuggets of wisdom about going about it .

Thanks 6.5

bunny shooter

Is there any point with a rimfire?

juice1304

https://www.youtube.com/watch?v=TlKgapL1VD0

clivej

6.5x55 wrote: »

Hi guys
I have just bought a new stock for a CZ452 .17 Varmint from Boyds in the USA and I want to Glass Bed it .I think that I saw a thread here about it can anybody point me in right direction or alternatively has any nuggets of wisdom about going about it .

Thanks 6.5

look through the tips section here , second page, and don't forget to add pillars while your doing it.

gunhappy_ie

bunny shooter wrote: »

Is there any point with a rimfire?

It is always worth removing play/giving better contact between a stock/action and of course the accuracy enhancement of floating a barrel has been covered a million times.

clivej

CZ 452 varmint in a custom bedded stock. I need to add pillars now.



Timney trigger

6.5x55

Hi thanks for prompt replies the tips section was helpful the video was better . With regard to Bunny shooter's query is it worth it .
Yeah i think it probably be worth it for the time and cost involved anyway a bit of a project .

Clive those photos were helpful now know what end project will look like .Thats a nice looking rifle did you notice much improvement when you completed the bedding Job.

Thanks again

clivej

6.5x55 wrote: »

Hi thanks for prompt replies the tips section was helpful the video was better . With regard to Bunny shooter's query is it worth it .
Yeah i think it probably be worth it for the time and cost involved anyway a bit of a project .

Clive those photos were helpful now know what end project will look like .Thats a nice looking rifle did you notice much improvement when you completed the bedding Job.

Thanks again

I got the stock and it was already bedded and I haven't done much in th eway of shooting with the varmint since I got it. But the CZ style in that stock would shoot 1/2" @50m very well.
If your doing the bedding put in the pillars as it will relieve the stress in the action/stock when you do up the action screws. I have just got allen head action bolts and it does put a lot of pressure on the stock now when doing up the bolts. So I will look into putting the pillars on the rifle now.

Vegeta

Was the timney trigger difficult to install Clive?

clivej

Vegeta wrote: »

Was the timney trigger difficult to install Clive?

piece of piss. knock out 2 pins put in the timney replace the 2 pins and do up a grub screw to hold it in place. allen key to reduce the trigger pull weight

Vegeta

clivej wrote: »

piece of piss. knock out 2 pins put in the timney replace the 2 pins and do up a grub screw to hold it in place. allen key to reduce the trigger pull weight

Going shopping for a new rifle Wednesday and this could be a great addition to it. Cheers

Bedding and 25 MOA rail would be sweet but sourcing rails (or people who ship them to Ireland) for those 452 rifles is a pain.

clivej

Vegeta wrote: »

Going shopping for a new rifle Wednesday and this could be a great addition to it. Cheers

Bedding and 25 MOA rail would be sweet but sourcing rails (or people who ship them to Ireland) for those 452 rifles is a pain.

can be done pm you about gitting a 25moa rail later, bed now early start for deer in the morning.

http://www.diproductsinc.com/Detail.aspx?PROD=112052&CAT=3600