Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Help!! Having a PA problem, need help

  • 16-09-2010 9:02pm
    #1
    Registered Users, Registered Users 2 Posts: 57 ✭✭


    We're having a problem with our PA, one side of our system is lower(volume wise) than the other. Even tho our amps are all running at the same levels. Its a deltamax setup, three amps, crown marco-tech(bin), matrix(mid), zeck(horn), going through a dbx driverack pa. can not figure out the problem. Any sound eng out there wanna help???

    Cheers!


Comments

  • Closed Accounts Posts: 5,277 ✭✭✭DamagedTrax


    probably stoopid and obvious but are all your drivers workin ok?


  • Registered Users, Registered Users 2 Posts: 57 ✭✭Pat182


    Yea all drivers worked perfect. If i swoop sides on the cables, the problem goes to the other side, know what i mean?


  • Closed Accounts Posts: 5,277 ✭✭✭DamagedTrax


    well if amps are out putting ok it must be a cable issue. you tried new cable?


  • Closed Accounts Posts: 5 hulioseducer


    hi pat the problem is almost certainly with the drive rack! Is it the pa or pa +?
    i had a similar problem a while back and fixed it quickest by preforming a factory reset and then redoing all my wizard settings!


  • Registered Users, Registered Users 2 Posts: 801 ✭✭✭PMI


    If you swapped sides and it changed it cant be the drive rack?!?

    We had this prob with a midas venice and it was the desk outs, one side was about 5db down.

    can you rule out the desk in anyway ie: mono out to each side of the amp rack and check?


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 801 ✭✭✭PMI


    just to add to the above when you say you swapped cables start by just swapping the initial input leads from the desk end....

    then move downwards, ie: swap side from out of the graphic and then down from there?!?


  • Registered Users, Registered Users 2 Posts: 57 ✭✭Pat182


    If i swoop round the XLRs goin out of the desk, if the problem is the desk then the lower volume should change to the another side, that right??


  • Registered Users, Registered Users 2 Posts: 801 ✭✭✭PMI


    It should swap sides but if it doesnt then its further down....


  • Registered Users, Registered Users 2 Posts: 57 ✭✭Pat182


    Cool, i'll give that a go so. But i have a feelin hulioseducer could be right, somethin tells me theres somethin up with the DBX driverack. I'll find out soon enough


Advertisement