If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)

Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Door Bell??!!

biffo22 · 2010-08-17 10:58:22

:o:oHey guys i never got to wire this in phase 2 so could some1 plz explain how to as in what mcbs used etc thanks:D

17-08-2010 10:58am

#1

biffo22

Closed Accounts Posts: 38 ✭

Join Date: October 2009

Posts: 25

:oHey guys i never got to wire this in phase 2 so could some1 plz explain how to as in what mcbs used etc thanks:D

0

Comments

#2 17-08-2010 8:18pm

forureyesonly

Closed Accounts Posts: 12 ✭

Join Date: May 2010

Posts: 9

OK its been ages since i have done one of these but here it goes!!

Get a door bell transformer to match the voltage of the buzzer and clip it on to the din rail in the board. Feed the primary side with 230 volts from a lighting circuit or if possible a separate circuit protected by a 3 amp mcb. BellWire should be connected to the secondary side of the traffo, take one core from the positive leg of the traffo through the push button and to the positive coil of the buzzer. From the Negative side of the buzzer coil run the remaining core of the bellwire to the negative side of the traffo.

0