Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Help with Aritech CD 9031 8 zone Remote Expander

Comments

  • Moderators, Home & Garden Moderators, Technology & Internet Moderators Posts: 24,789 Mod ✭✭✭✭KoolKid


    What are you trying to do. All the address settings etc are in the Engineer manual.If you need any help with an expander start a thread & I'm sure we will be able to get you sorted.


  • Closed Accounts Posts: 2,389 ✭✭✭Carlow52


    KK: Thanks for reply.( the original question is explained below)

    Have the following in a house we moved into.

    CD 7203 with 3 CD 3008 keypads and 2 CD 9031 Expanders.

    There is a fault with a Pyronix PIR Enforcer FP04902 thats on its own circuit and when trying to find the correct circuit I found the RLE in the attic and only the power and alarm wires were in use, with no use of the TAM circuit; I have discovered its a 3 wire (dual system).

    I have both the normal access codes and the engineers code and the following documentation

    User Manual.

    Installation Manual.

    I would like to add fire sensors to it and have part guard etc, hence the request for the manuals as listed in the installation guide.
    Thanks.


  • Moderators, Home & Garden Moderators, Technology & Internet Moderators Posts: 24,789 Mod ✭✭✭✭KoolKid


    [thread split]
    Hi Carlow52 , I have moved this away from the manual requests thread.
    We will be able to help you better in a seperate thread.
    If you wish to post up a seperate request for the manual in that thread please do so. I just want to keep manual requests tidy & free of other discussions.:)

    If the PiR is wired duel then 2 wires is sufficiant.
    See example 2 in the attached diagram.
    Tamper protection is covered on the PiR as shown so no wiring into the aux tamper on the RLE is required.

    You could add Fire sensors by wiring into a spare zone on the expaner in the same way as the PiR.
    To set a zone to be off in partguard .
    In engineer menu goto.
    Zones > Zone Attributes > Zone number > Press accept > Arrow down untill PG appears on the right & press accept. Display should show IN PG.
    If the PiR is on an entry route you need to add the attribute Access (AC) in the same way as above)


  • Closed Accounts Posts: 2,389 ✭✭✭Carlow52


    Thanks kk for diagrams etc. [ any recommendations for fire alarm units?

    Tried to inhibit an open zone last night so as to leave the velux windows in locked but open position.

    Followed the user manual and got a "Not allowed" response.


  • Moderators, Home & Garden Moderators, Technology & Internet Moderators Posts: 24,789 Mod ✭✭✭✭KoolKid


    For 12 v smoke alarms either EI or aritech , is what I use.
    To be allowed inhibt a zone the your user code must have the IN atttribute & the zone in question must have the IN attribute.


  • Advertisement
Advertisement