KWA hopup problems

.22 Lover · 14-11-2009 12:30pm #1

Hi my KWA Glock26C's hopup is not sitting the BBs in an there falling out i tried to remove the barrel once and failed so now the hopup is destroyed so anyone have any advice or help.

Leftyflip · 14-11-2009 12:52pm

How is it "destroyed"?

.22 Lover · 14-11-2009 1:15pm

Small parts of rubber are falling off witch has resulted un a crack witch only gets bigger as i adjust the hopup.

Leftyflip · 14-11-2009 1:19pm

You need this. Just fit it and you're grand.

.22 Lover · 14-11-2009 1:21pm

Will that fit a KSC G26C?

Leftyflip · 14-11-2009 1:22pm

Should do, as far as I know most pistol hops are the same.

.22 Lover · 14-11-2009 1:24pm

Do you know how hard it is to fit as thats how i destroyed it last time.

Leftyflip · 14-11-2009 1:26pm

I'm not familiar with Glocks but I'd imagine it just slips on over the end of the barrel?

.22 Lover · 14-11-2009 1:50pm

Ill have to trust you on this one cause i havent got a clue

Masada · 14-11-2009 2:29pm

This is the one you need, Its not in stock at Redwolf at the moment but they can usually be found on ehobby aswell.

http://www.redwolfairsoft.com/redwolf/airsoft/ProductDetail?prodID=22199

.22 Lover · 14-11-2009 2:43pm

:DCheeres

Leftyflip · 14-11-2009 2:58pm

Whoops!:o

.22 Lover · 14-11-2009 3:32pm

Masada wrote: »

This is the one you need, Its not in stock at Redwolf at the moment but they can usually be found on ehobby aswell.
http://www.redwolfairsoft.com/redwolf/airsoft/ProductDetail?prodID=22199

How hard is it to take out and refit the hopup rubber.

Masada · 14-11-2009 7:48pm

Its pretty handy. I cant remember the exact proceedure for the Glock but you just take off the slide, remove the barrel and i think there'll be a screw there. theres not much disassembling once ya actually have the barrel in your hands.

.22 Lover · 14-11-2009 8:20pm

Well thanks for the help:D

Stercus Accidit · 15-11-2009 3:07pm

ksc/kwa hop designs are awful, you may have some trouble getting it apart.

Be sure to post up here if you do, I've had to take a couple of ksc hops apart and they are the worst design I've ever seen, and are a particular bastard to dismantle on the usp, hopefully the glock will be ok.

.22 Lover · 15-11-2009 6:30pm

Any tips???

Stercus Accidit · 15-11-2009 7:08pm

Google a takedown guide, all I'm saying is it could be fiddly, or not too bad, useless advice really!
But do a bit of research and take your time and it should be fine.

KWA hopup problems

Comments