Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

STUPID FIN QUESTION!

Options
  • 19-05-2009 1:59pm
    #1
    Donal94
    Registered Users Posts: 223 ✭✭


    i'M AFTER BUYING A BIC MAGNUM 8'4 AND i CANT SEEM TO GET THE LARGER OF THE THREE FINS INTO THE CHANNEL TO SECURE IT. ANY HELP WOULD BE APPRECIATED AND I REALISE I'M AN IDIOT BEFORE ANYONE SAYS IT!!!!
    THANKS


Comments

  • Options
    #2
    loctite
    Registered Users Posts: 589 ✭✭✭loctite


    Maybe you are not the idiot, if it doesn't fit it doesn't fit. Why don't you call the shop and see. They may have given you the wrong size fins?

    Some of the Moulded boards have different size fins for different size boards. I know that this is the case with NSPs so could be the same with Bics.... Maybe there was a mix up in the fins that they sold you???


  • Options
    #3
    Donal94
    Registered Users Posts: 223 ✭✭Donal94


    Thanks for the reply allthough i think I may still be an idiot! I can get the front of the fin in the bit with brass "nipples" either side but i cant get the bit with the brass square and screw in. Should this be put in attached to the fin and then tightened or should i put the brass square in by itself and then screw the fin into that?


  • Options
    #4
    Decos
    Registered Users Posts: 243 ✭✭Decos


    Just hammer the **** out of it
    itll be grand
    :p


  • Options
    #5
    Donal94
    Registered Users Posts: 223 ✭✭Donal94


    All sorted now, I was right I was being an idiot! Thanks for the replies


Advertisement