Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

KWA Glock 23F Review

  • 31-03-2009 7:56pm
    #1
    Closed Accounts Posts: 190 ✭✭


    KWA Glock 23F


    DSC00141.jpg

    To start, overall a great gun. Full auto is brilliant but a bit pointless without a 50 round mag. Blowback is great fun and really realistic. Surprisingly heavy, heavier when compared with a KJW M9. Magazine is metal and very heavy. Takes 23 BB's and on semi in decent conditions will last 2-3 mags. On full you might get 1 and a half mags if you are lucky. No leaks at all.


    DSC00140.jpg

    Selector is probably the only bad part of the gun. Very flimsy and badly made. Can sometimes get stuck and has fallen out twice. IF, LIKE ME, YOUR SELECTOR DOES FALL OUT, THERE IS THE MAIN SELECTOR PART AND A TINY, METAL BALL BEARING. BE VERY CAREFUL WITH THIS BEARING AS IT IS TINY, HARD TO REPLACE AND VERY EASILY LOST.

    DSC00145.jpg
    DSC00152-1.jpg
    DSC00146-2.jpg

    The mag's fill valve is covered by a plate simply pull down the little tab shown here.
    DSC00143-1.jpg

    After pulling this down, slide the base plate across.

    DSC00144.jpg

    This gun shoots in and around 315 fps ( varies depending on weather ). You can use either HFC 134a gas or Green Gas. The 315 fps is with green gas. Its quite accurate from about 20 feet. Accuracy is pretty bad from any further away. You can strip the slide in less than a minute. You put the selector into the disassembly position then slide down the two tabs on either side of the gun. The slide will slide off. This could be handy for replacing the outer or inner barrel or the recoil rod/spring.


    DSC00150-1.jpg
    DSC00149-1.jpg
    DSC00151-1.jpg

    To conclude,

    Performance - 10/10
    Fit/Finish - 8/10
    Value - 10/10

    If you have any questions, feel free to PM,

    MiniAirsofter


Comments

  • Registered Users, Registered Users 2 Posts: 3,157 ✭✭✭Compton


    to change the mode you must pull the slide back an inch then switch modes


  • Closed Accounts Posts: 190 ✭✭MiniAirsofter


    shblob wrote: »
    to change the mode you must pull the slide back an inch then switch modes

    You don't have to pull back an inch, just a centimetre or two sometimes.


Advertisement