Curtains and Curtain pole query

purerandom

hi,
ok, i have 2 windows in my sitting room 77cm apart. the measurements are 90cm x 130 cm, 70 cm from bottom of window to the floor and there is a gap of 77cm between the windows.
should i use 1 curtain pole across both windows or get a curtain pole per window. I am not sure what to do, what would those with the knowledge advise?

thx for any help!

Simply Red

What I would do is use 2 separate curtain poles, 1 per window, and just buy 1 pair of curtains, hanging 1 curtain on each pole. I've seen done this many times before on similiar type windows and thought it always looked very well. I attempted to draw a picture of what im suggesting on paint, its not the best but sure you'll get the idea

dlambirl

Thats a great diagram!! You should see if i tried to draw anything - one word DISASTER!!!

Anyways back on point --> i am in a similar situation soon when i move into my new house the living room and sitting room both have two small windows close to each other and i dont know whether to put one big curtain or two small ones.

The other posters idea is grand, dont know if it would be my cup of tea, i'd have to see it done if you know what i mean. I would be more inclined to go with two seperate curtain poles and two sets of curtains even if when they are pulled back they meet in the middle.

El Camino

I've a similar curtain query. Both my sitting room and bedroom have a bay window. Approx 220 x 140mm wide and each of the smaller side windows are 60x140mm. I'm finding it hard to get a curtain pole that will go straight around and cover all windows. I can't find a curtain pole that will turn at 90 degree angle for the corners.

Some of my neighbours have put a straight curtaian pole up across the front and two smaller ones on each side. Essentially they have 2 pairs of curtains on one window. I don't like this at all and am trying to find something.

I have found a curtain rail system inikea that will do but it looks quite light and may not be strong enough to hold heavy curtains. Any ideas or recommendations?

Ikea Kvartal curtain rail http://www.ikea.com/gb/en/catalog/products/70079368

fozzle

Purerandom I'm with Simply Red on this - with the gap between the two windows being so close to the same width as the windows themselves I'd go down the two poles, one pair of curtains route. Putting one pole across will make the wall look narrower.

El Camino, it IS possible to get poles with 90' joints. Harry Corry (yes I am connected to the company) sell two kinds - one for eyelet/ring-top curtains and one for regular taper-top curtains (this one has 7 brackets so it'll hold super-heavy curtains. If there's a store in your area that does made to measure stuff there's a chance they can make you a similar pole too. They won't be cheap from anywhere though - if you're on a budget you can get flexible tracks from most shops selling poles. They're less attractive and don't usually hold as much weight as a pole though.

lily marlene

El Camino wrote: »

I've a similar curtain query. Both my sitting room and bedroom have a bay window. Approx 220 x 140mm wide and each of the smaller side windows are 60x140mm. I'm finding it hard to get a curtain pole that will go straight around and cover all windows. I can't find a curtain pole that will turn at 90 degree angle for the corners.

Some of my neighbours have put a straight curtaian pole up across the front and two smaller ones on each side. Essentially they have 2 pairs of curtains on one window. I don't like this at all and am trying to find something.
I have found a curtain rail system inikea that will do but it looks quite light and may not be strong enough to hold heavy curtains. Any ideas or recommendations?

Please do not waste your money on these bay window poles. I have yet to see one that is not a poor solution. go into any curtain shop telling them that you wish to get a bay window pole made.slightly more expensive but is fitted on 3 brackets and allows you to hang any type of curtains in one pair which will close at the centre. some shops will just give you a contact number of the tradesman allowing you to deal direct. Where are you based?

El Camino

Thanks for that!! I continued my search over the weekend and actually found a solution in a local shop. I'm based in Laois. This is a metal pole which can be cut into the 3 lenghts required and a corner joint added. THe hools that are required however are C-shaped and are very likely to get caught on the bracket as curtains are opened or closed. This is likely to cost me approx €220 for the rail all in.

the only other option that was offered were these light plastic rails that can be bent to shape. Definitely out of the question.

I'm going to continue my search but this is the favourite at the moment.

Lily Marlene what is it that you are suggesting?

yop

We have a bay similar, its made of of 3 rails but they are joined but 2 knucles which allows the 2 curtains to be pulled across the 2 side window and which meet in the middle and cover the big window.
The curtain "eyes" are C shapped allowing them to pass over the knuckle, we find the solution sound though in fairness.

But we got the curtains made and pole I presume was made also.

I wonder if I could find a pole and knuckles like this allowing me to make it??? I think the 2 curtains and poles cost us 900 euro for the window.

lily marlene

sorry I didnt make it very clear what I meant by a made to measure bay window pole. these are a continous pole with no hinged joints they follow the angles of your bay window exactly. Any local who works in wrought iron will have experience of making and fitting them. No need for c rings etc.

check out baycurtainpoles.com to clarify

Then contact whoever makes gates railings etc locally and I guarantee that thay already make these curtain poles

JuliusCaesar

lily marlene wrote: »

. No need for c rings etc.

check out baycurtainpoles.com to clarify

Can't see from the website how they get the rings over brackets. They say they only use C rings when there're more than 5 brackets. Oh, I think I get it: 3 brackets would be one in the middle and one at each end. I think my square bay would just have angles that are too acute...shame.

lily marlene

JuliusCaesar wrote: »

Can't see from the website how they get the rings over brackets. They say they only use C rings when there're more than 5 brackets. Oh, I think I get it: 3 brackets would be one in the middle and one at each end. I think my square bay would just have angles that are too acute...shame.

believe it or not 3 brackets works perfectly on square bay. I have this in my house and you could swing from it its that secure.

El Camino

Ok i see what you mean... Looks like a good idea!! I'm thinking the same as JuliasCaesar 3 bracket just doesn't seem enough, but I'm willing to explore as I'm against the C-hooks. The other thing is that wrought iron just isn't as nice as the brushed steel finish that i have seen. Guess you can't have everything though, Right!!

El Camino

Got the original option with the C-hooks fitted. It has 5 brackets and looks very sturdy. It's a very tidy finish all in all and I'm glad i went with this. I haven't got the curtains yet so I can't be absolutely sure it was the right choice... time (& curtains) will tell!!