MP5 SD5 Inner Barrel

Irishmaster

Hi does anyone know how to get to it on a JG version full stock? Ive seen other vids on them like the gng where the mechbox just slides out by taking out 2-3 pins. Ive taken out the 2 mag release pins and the stock pin out. What am i doing wrong here? Does the little grub screw in the fireselector need to come out too? Or does it come apart like the awkward video on mechbox?

Thx for any help!

Masada

You'll need to remove in this order,

The fire selector,
The 2 body pins, 1 at the stock, and the other at the mag release.
The motor plate off the underneath of the grip,
The motor and the 2 screws down in the motor well.

The lower reciever will now come away and make sure not to loose the littlw plastic bit in the fire selector.

If the gun is wired to the stock then the gearbox wil just slide out the back anf the hopup and barrel do the same, it its front wired to the foregrip then theres a few other steps before it comes out.,

**Now remove the Rear sight and theres a screw on the left side of the gun under the part of the body where the stock would cover.
Theres another screw at the magwell.
Once those are out you can split the body of the gun and remove the gearbox.

Irishmaster

The wiring is at the back. Why couldnt they make it as simple as the gng! Lol. I will try that when i get a tincy alan key to get the fire selector off. I already have the small tiny one but this seems to be even smaller.
Thx again Vtec!

Masada

I use a small torx for removing them, i think its a T5 or a T6 torx. same size used for opening a nokia phone,.,

Irishmaster

My smallest torx is a t10. Do you know where you can get those small torx sets or tincy allen keys?