Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Alarms: Airtech CS 350 wont arm

  • 26-07-2008 9:40am
    #1
    ttcomet
    Registered Users, Registered Users 2 Posts: 469 ✭✭


    There is a Airtech CS 350 in our new house and when we try to arm the alarm we get a message saying "Open zones" then "cabinet tamper" and it wont allow the alarm to activate. It only started happening the other day after the panic alarm was pressed (by mistake). Is there any way around this?

    I don't have the engineers code (tried the default and it didn't work).


Comments

  • #2
    fred funk }{
    Registered Users, Registered Users 2 Posts: 6,827 ✭✭✭fred funk }{


    It's eirther the lid of the panel is off/not on properly or the aux tamper is open. First thing I would do is give the front of the panel (not keypad) a light smack with your hand.


  • #3
    Jnealon
    Registered Users, Registered Users 2 Posts: 2,071 ✭✭✭Jnealon


    Also check the sensors for a loose cover


  • #4
    dingding
    Registered Users, Registered Users 2 Posts: 4,940 ✭✭✭dingding


    And check with the panic button that you don't need a key to release the button. Is the panic button held in or did it pop back out when released.


  • #5
    fred funk }{
    Registered Users, Registered Users 2 Posts: 6,827 ✭✭✭fred funk }{


    dingding wrote: »
    And check with the panic button that you don't need a key to release the button. Is the panic button held in or did it pop back out when released.

    That shouldn't be the problem if the alarm is installed correctly. It's possible that the panic is wired into the tamper circuit (which isn't correct) but it's possible.


  • #6
    ttcomet
    Registered Users, Registered Users 2 Posts: 469 ✭✭ttcomet


    I already used the key to reset the panic button and it popped back up so I dont think that is it. I will look at the panel cover and check the sensors. Thanks for the replies.


  • Advertisement
  • #7
    mfas
    Registered Users, Registered Users 2 Posts: 2 ✭mfas


    Hi guys I recently moved in a house and it have an aritech Cs 350 house alarm it keep on saying battery low which I am aware that I will have to change but when I tried to armed the system it won't armed as it keeps on saying 03 zone and disable after that I have checked all the doors and windows if they are closed properly but still same problem so after reading the manual online I tried to inhebit 03 zone but it won't let me any ideas well appreciated thanks


This discussion has been closed.
Advertisement