Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

apt timer wiring

  • 23-05-2008 9:31am
    #1
    Registered Users, Registered Users 2 Posts: 263 ✭✭


    I had my electrician in twice yesterday to connect up my immersion. the first time after he left I discovered it still wasn't working, so he came back and it was a wiring problem. It was working after he left, however I discovered later that the timer still wasn't working it hadn't moved on. I am assuming that it is a wiring problem but I am loath to call him back again. I have some electrical experience myself and if someone could tell me what the problem might be, I might be able to fix it myself. Any help would be appreciated.


Comments

  • Registered Users, Registered Users 2 Posts: 10,952 ✭✭✭✭Stoner


    em timers can be a bit tricky, but APT ones are about as easy as they can get.


    what model APT time have you got?


  • Registered Users, Registered Users 2 Posts: 46 Dg_


    Sounds like he's an apprentice electrician if he cant wire a timeclock properly, he may have put the supply (live in) into the live out side of the clock, it would work when its switched to ON but wen switched to OFF the supply would be cut to the timer, so maybe its just a matter of swapping the connections, its usually wrote on the under side of the timer wat the connections are, the wire leaving the live out connection should be going to your immersion switch, and just check all the connections are tight when your finished.


  • Registered Users, Registered Users 2 Posts: 2,345 ✭✭✭NUTLEY BOY


    And check that the connections have been snugged up properly - not loose and certainly not too tight.

    We had a sparks put in one of those years ago and he didnt tighten up the connections adequately. As a result arcing occurred under working load and the blasted thing burned out. :mad:


  • Registered Users, Registered Users 2 Posts: 263 ✭✭Foleyart


    Thanks for all the input guys, as it happens when I opened it up the clock re-started. It may be that it was jammed in some way when he tightened the screws. at any rate it is working fine now. Thanks again.:D


  • Closed Accounts Posts: 1,113 ✭✭✭fishdog


    as it happens when I opened it up the clock re-started

    I dont want to alarm you, but that sounds like it may be due to a bad connection. With a load such as that (3kW) a bad connection can be a fire hazzard. This is an educated guess, so although I may be wrong you should call him back to check it out and not use the immesion until then!

    The bad connection may be within the clock (faulty clock), so not the electrician's fault.


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 263 ✭✭Foleyart


    Thanks Fishdog, I did check the connections and they all seemed ok. I reckon it was the way the excess wiring was squashed up in the box when he tightened it up that caused the clock to jam. Any way it is working fine now but I will keep an eye on it thanks.


Advertisement