Help installing pickups

DeadSkin

Hoping someone can help me out here.
Got my GFS Power Rails pickups for neck & bridge of my RG321.
I got the schematics of the RG321. Am confused as to how to wire the new pups.
Emailed guitarfetish twice and they just send out the same email;

All GFS Humbuckers wire the same way-
Green = + This is the Hot wire, usually soldered
directly to the toggle switch or leftmost tab of that
volume control.
Red/White pair solder to each other. No Contact
(Tape them off) is for Humbucker sound, Connect to
ground for Single Coil sound.
Black and SIlver solder to ground. We like the back
of the volume pot.

I have uploaded a file there, Pickups, this is my understanding of what they say. The blue wire in the drawing is physically the white wire.
Is this correct?
Where he says, solder the green wire to the toggle switch or leftmost tab of the volume control, does it matter which one, the toggle switch or tab of vol control??
Any help much appreciated, thanks.

Duff_Man

dunno if this will help you at all but whenever i put pickups in a guitar i just copy the way it was done already.

feylya

You nearly have it. The problem there is that you will have both pickups on at the same time. This might be helpful:

DeadSkin

Cheers lads.

Feylya, that schematic you got from SD is for a 3-way switch. I have a 5-way switch, does this mean I have to incorporate the Red & White wires into the circuit ie. not have them taped off together
There are no wires taped off in the guitar as it is now
I'm trying to find the colour codes for the INF pickups and then try and translate them to the GFS codes, this then should be a pretty straight forwad swap, but havin' no joy.

feylya

There ya go then

DeadSkin

How the feck did I miss that :eek:
Muchos gracias dude