Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Help needed with dish and motor

  • 19-07-2007 5:13pm
    #1
    Registered Users, Registered Users 2 Posts: 1,557 ✭✭✭


    I have set up a 80cm Triax and a Diseqc 1.2 .Im a bit confused about the arch plate on the back of the dish it has markings from 0 to around 40 .where do i set the clamp to ??? .im wondering aswell if im right in setting my motor to 53 degres and 37 elavation would this be right . Ive not got my receiver yet "Tomorrow with a bit of lot " but i i just want to make sure im set up for it comes .
    heres some pics of what im on about the main question is where to clamp onto that arch on the back of the dish ?





    674hwtg.jpg


    4lig1ag.jpg


Comments

  • Registered Users, Registered Users 2 Posts: 1,733 ✭✭✭Zaphod


    The clamp at the back of the dish is where you set for the declination angle. For most of Ireland, the declination angle will be about 7 degrees. However, the actual setting you use is based on your model of motor and it requires an adjusted declination angle using a specific formula. This will be in your manual.

    This will (hopefully!) clarify things:
    http://bytelive.com/wiki/tiki-index.php?page=How+to+install+and+align+a+Diseqc+motor


Advertisement