If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)

Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

usals problems

bernard0368 · 2007-05-29 15:05:16

I have a 90cm dish on a motor with a technomate receiver. The whole lot was originally set up using disqec i have been trying to convert it to Usals but I loose all the satellites. Any ideas would be appreciated.

29-05-2007 3:05pm

#1

bernard0368

Registered Users, Registered Users 2 Posts: 1,424 ✭✭✭

Join Date: May 2007

Posts: 1280

I have a 90cm dish on a motor with a technomate receiver. The whole lot was originally set up using disqec i have been trying to convert it to Usals but I loose all the satellites. Any ideas would be appreciated.

0

Comments

#2 30-05-2007 1:10pm

Zaphod

Registered Users, Registered Users 2 Posts: 1,733 ✭✭✭

Join Date: October 2002

Posts: 1516

Try reseting the diseqc motor - insert a pin into reset cavity under motor for 5 seconds.

0
#3 30-05-2007 5:02pm

watty

Registered Users, Registered Users 2 Posts: 32,417 ✭✭✭✭

Join Date: April 2001

Posts: 31520

Also the motor must support Goto X and you must put your own correct lat & long in sat receiver.

If the motor was misaligned all the satellites will be out, but might have mostly worked with manual storage, send it to 30W or 42E via USALS and check motor on pole by slight rotate of bracket.

0