Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

knocking supporting wall in timber frame house

  • 01-02-2007 11:54pm
    #1
    maireadH
    Registered Users, Registered Users 2 Posts: 37 ✭


    Hi,

    We're planning on knocking a supporting wall between two rooms. Our house is a timber frame house. I know for a concrete house an RSJ would be the norm but what should we be looking for in a timber frame house? Supporting an RSJ with a timber frame could be difficult. The builder suggested oak beams but we're concerned that these may not be strong enough or of shrinkage. What is usual in a timber frame house?


Comments

  • #2
    boarduser01
    Registered Users, Registered Users 2 Posts: 68 ✭✭boarduser01


    We have an rsj in our timberframe house, it was designed that way!


  • #3
    kadman
    Moderators, Home & Garden Moderators Posts: 5,126 Mod ✭✭✭✭kadman


    In order to remove a load bearing panel in a timberframe structure , you would have to replace the panel with a glulam beam , or a steel support beam that would have the same load carrying capacity , or better, than the panel you are removing.

    The ends of the new support beam would have to be placed into 2 support pockets formed in the panels running at 90 degrees to your existing panel, if the new beam is to be placed below the ceiling/floor that its carrying. This would be the easier option than placing it in the floor zone. Either way , the ends of the beams would also need to have additional vertical supports placed below them , down to the foundation level.

    In short this is a job that first needs to be assessed by a competent timberframe engineer / designer , before any work commences.

    kadman


Advertisement