For green hobby (I Think)

g5hn710m4xpdwy

Hey
I was out with my bro tonight just running around when he decides to see how fast my carson stormracer 2 can go but very quickly and llike i know its range is much much better than what happened, it just lost all signal and i dont have a failsafe fitted so it just went up the hill faster and faster as it went when it took a turn for the worst (literely) it self turned into a kerb and smashed up the front left area of trhe car!
man i am annoyed at him
well any way am i able to get all the parts from green hobby ordered in? if so can i get like better grade one or anything?
thanks

tallus

I think they have spares, when i got mine there were a few of the same part there at the time.
Do you know the part number by any chance? if it's the one I'm thinking of its the suspension arm thingy #11415 check out the manual heh, when I'm speed testing mine I always make sure it's coming towards me .

g5hn710m4xpdwy

Kk thanks, and can you remember how mcu h they cost about?

tallus

less than 9 euro

g5hn710m4xpdwy

thats grand thanks now i wanna get a dremel, a psp with gta and a savage for about 200 :P what am i thinking......
_____
oh yeah i forgot to say i did damage to the rim to cracked it and it all like \____ yeah my work sux but its simplily been displaced so should i get some new rims? or shall they do if i just push it back?

tallus

lol models are addictive heh ...

no leaf clover

flunked- had my buggy only a short while, lost range, it sped right up, hit a curb twice its size, climbed it in seconds, drove on and got stuck in a hedge, force cused everything supported in the......."top thing""!! (sorry word is gone!!) to shatter, two servos, irreparable, and my fuel tank snapped back breaking a bit off the bottom which i only noticed when the fuel i was pouring in....was pouring out!!!!! (not good on aunties new cobbelock!!!

g5hn710m4xpdwy

what happened to you tank basicly happened to me just after i put a full tank in so that was a tank gone to newspaper :P

g5hn710m4xpdwy

ok well i got the pares and fitted em last week it came to a total of.... €40:D
i got home and noticed i should of got a front knucle arm (the axel keeps dropping out atm:o and some speacil screws and since i am going to be ording em by fine i should get a glowplug cause i dont feel mine is doing as good as it was ;-/

anywho after i fitted the spares and got it all running (with normans tip for the rubber band failsafe) the engione starts but that after just pulling the pullstart with my finger over the exhaust about 5 times then priming it about 3 times then it will start but... (there is alwasy a but)
i have to immediatly give it very high - max throtle on the transmitter so it will go and then it cuts out about 20 or 3 meters away, but if i keep hold of it and whenever i here it about to die i prime it it goes but i have to keep doing that so yea
this oly happened after the spares and a new fuel tank so could that have anything to do with it? and i think i will re tune it with my bro today or tomorrow
thanks

no leaf clover

new fuel tank should be thae only factor that could have effect ontit

g5hn710m4xpdwy

well.... i cant use the old one cause that has a big hole in it.... :rolleyes:

no leaf clover

heh heh yeh but is every thing secure on the new one?

g5hn710m4xpdwy

i think so... no leeks and its well screwed down if that what ya mean

coolwings

Could be a faulty tank that has a partial airseal, almost enough but not quite...
But much more likely - the idle jet is just set a bit too lean....
eg Idles rather fast - kicking into gear when you startup - cuts out at 20-30% of throttle when you rev up......
There is a diagnosos and cure section on my website on the
running-in page which might help if this is the cause.
Look for the bit about "What Happens if the Engine is Set Too Lean" and also the bit about "Setting The Slow Jet"

Hope this helps.

tallus

Exellent site N.