IMAX B6 Chaarger (INPUT VOL ERR)

SickMusicMan

Hey everyone.

I hope someone can help me with an issue I'm having with my new IMAX B6 Balance Charger. Every time i plug the charger into a mains power supply or a car battery I keep getting the same input voltage error message and a really annoying beeping noise :mad:. If i try to go and change the battery settings the error comes on again . It wont allow me to go into any of the setting screens.

Has anybody else had the same problem?

Regards,

Liam.

goblin59

i had the same problem., seem to fix it by changing the charge rating to 0.4a when choosing the settings.

SickMusicMan

Cheers for the reply goblin59, but every time i try to change the settings, it starts beeping at me and showing the same fault message .
It wont let me change anything.

goblin59

it should give you the option to change it by just clicking enter once, then amps will start flashing, use up and down to change that, then once it is set hold in enter untill it starts the charging sequence

SickMusicMan

I had to get it replaced in the end, but cheers for the advise and help