Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Yanmar b15-3 Mini digger.... Rubber Track.. Help

  • 26-07-2015 11:43pm
    #1
    Edward9
    Registered Users Posts: 42 ✭


    Yanmar b15-3 Mini digger

    Looking for advice. The rubber track of digger is losing grease that keeps it tight. The nipple is ok. The nut that holds the nipple is tight but it appears to be loose on up and down movement. When you put a socket on the nut the grease nipple holder moves up and down easily. My question is there a part gone or is there something loose?
    I cant find manual to check this out.
    Tagged:


Comments

  • #2
    tomwaterford
    Closed Accounts Posts: 16,768 ✭✭✭✭tomwaterford


    Most likely a seal/o ring on the adjuster ram

    It is same principle as a hyd ram but just worked off grease
    Usually cheap fix unless chrome corroded


  • #3
    Edward9
    Registered Users Posts: 42 ✭Edward9


    tomwaterford wrote: »
    Most likely a seal/o ring on the adjuster ram

    It is same principle as a hyd ram but just worked off grease
    Usually cheap fix unless chrome corroded



    Thanks very much Tom. When one takes off the track is it a big job to get into the Ram?


  • #4
    tomwaterford
    Closed Accounts Posts: 16,768 ✭✭✭✭tomwaterford


    Edward9 wrote: »
    Thanks very much Tom. When one takes off the track is it a big job to get into the Ram?

    Usually pull out idler pulley/sprocket....it shouldn't be that big a job after that....should become relatively apparent after that...must be years since I did one if I'm honest :O


  • #5
    Edward9
    Registered Users Posts: 42 ✭Edward9


    tomwaterford wrote: »
    Usually pull out idler pulley/sprocket....it shouldn't be that big a job after that....should become relatively apparent after that...must be years since I did one if I'm honest :O

    Thanks any problems I will get back to you


Advertisement